Tektronix AWG7 1B Series, Service Manual, Page: 63 / 174

Removal and Installation Procedures
Table 4-3: Tools required for module removal and reinstall (cont.)
Item # Name Description General Tool #
7. 3/16 inch open-end
wrench Used to remove nut posts Standard tool
8. Pliers Pliers modi fi ed for use in SMP
cable insertion/extraction
003-1895-00
9. 5/16 inch torque
wrench (8.0 in-lbs) Used to remove SMA cables
10. Angle-Tip Tweezers Used to remove the front-panel
knob Standard tool
11. Wire cutter Used to remove cable ties Standard tool
Disconnecting and Connecting the SMP Cable
When you disconnect or connect the SMP cable, use the pliers speci fi ed in the
required equipment table and keep the connector vertical. If excessive sideways
force is applied, the connector is damaged.
Figure 4-3: Disconnecting and connecting the SMP cable
AWG7000B and AWG7000C Series Service Manual 4–9