Tektronix AFG3000 Series, User Manual

Page: 50 / 113

Instrument interface, front panel, and rear panel
3. To select a sweep
waveform, push the
Sweep button.
You can read more about
sweeping waveforms.
(See page 55.)
4. To select a burst
waveform, push the
Burst button.
You can read more
about Burst mode. (See
page 54.)
Adjust Waveform Parameters
When you turn on your instrument, the default output signal is a 1 MHz sine
waveform with an amplitude of 1 Vp-p. In the following example, you can change
the frequency and amplitude of the original output signal.
1. Push the front-panel
Default button to display
the default output signal.
2. To change frequency,
push the front-panel
Frequency/Period
shortcut button.
36 AFG3000 and AFG3000C Series User Manual