Tektronix 4000 Series, User Manual

Page: 156 / 326

Trigger Setup
9. If you are setting up a CAN trigger and have
made a
Trigger On selection of Type of
Frame , push the lower-bezel Frame Type
button, and select Data Frame, Remote
Frame, Error Frame, or Overload Frame.
If you have made a
Trigger On selection of
Identi fi er , push the lower-bezel Identi fi er
button, and select a Format . Then push the
Identi fi er side-bezel button, and enter a binary
or hex value with multipurpose knobs a and b .
Push the lower-bezel menu Direction button
and select the direction of interest: Read ,
Write , or Read or Write .
If you have made a Trigger On selection
of Data . Push the lower-bezel Data button
and enter the parameters of interest with
multipurpose knobs
a and b .
138 Tektronix 4000 Series Oscilloscopes User Manual