TM 11-6625-3145-14
APPENDIX B
COMPONENTS OF END ITEM LIST
SECTION I. INTRODUCTION
B-1. Scope
The appendix lists integral components of and basic issue items for Logic Analyzer, TEK Models 318/338 to help you
inventory items required for safe and efficient operation.
B-2. General
This Components of End Item List is divided into the following sections:
a. SECTION II. Integral Components of End Item. These items, when assembled, comprise the Logic Analyzer, TEK
Models 318/338. These components must accompany the End Item whenever it is transferred or turned in. The
illustrations referenced will help you identify these items.
b. SECTION III. Basic Issue Items. Not applicable.
B-3. SECTION II. Integral Components of End Item. Explanation of Column Entries.
a. Column 1, Illustration. This column is divided as follows:
(1)
Column A, Figure Number. Indicates the figure number of the illustration on which the item is shown.
(2)
Column B, Item Number. The number used to identify the item called out in the illustration.
b. Column 2, National Stock Number. Indicates the National Stock Number assigned to the item, the number will be
used for requisitioning.
c. Column 3, Description. Indicates the Federal item name and, if required, gives a minimum description to identify
the item. The Part Number indicated is the primary number used by the manufacturer, which controls the design and
characteristics of the item by means of its engineering drawings, specification, standards, and inspection requirements to
identify an item or range of items. Following the Part Number, the Federal Supply Code for Manufacturers (FSCM) is
shown in parentheses.
d. Column 4, Location. The physical location of each item listed is given, The lists are designed to inventory all items
in one area of the major item before moving into an adjacent area.
B-1
Summary of Contents for 318
