Note: To trigger on a bus, you must first add the bus to the Waveform view. See
on page 71
Note: Triggering on buses other than Parallel requires the purchase and installation of serial trigger and analysis options. See
the Tektronix Web site for available serial trigger and analysis options.
3. Select the other fields to refine the trigger conditions. The menu fields and trigger graphic update as you make changes to the trigger
settings. Displayed fields depend on the selected trigger type. Selection changes take effect immediately.
4. Tap the Help icon on the menu title for more information on these settings.
5. Tap outside the menu to close the menu.
Set the acquisition mode
Use this procedure to set the method the instrument uses to acquire and display the signal.
Procedure
1. Double-tap the Acquisition badge on the Settings bar to open the Acquisition configuration menu.
2. Select the acquisition method from the Acquisition Mode list. Set any other parameters associated with the selected acquisition type.
Analog channel operating basics
3 Series Mixed Domain Oscilloscope Printable Help
68
