BD-1/07-002
16
For VPC301 keypad;
Option
Address
Default Value
LCD Menu
Enabled/Disabled
15 01
Enabled
(option1)
Panel Settings/Remote Access/Remac Options
Ring Time
15 02
5 (times)
Panel Settings/Remote Access/Ring Count
There are two ways of communication with your system;
10.1. If the user calls the system
*
This feature can not be used in VAP2xxx and VAP3xx alarm panel.
When you call the system, system answers the phone with a short melody.
Option
Command
Buttons
Arm/Disarm
Disarm
* 0 0 #
Arm
* 0 1 #
PGM1
Off
* 1 0 #
On
* 1 1 #
PGM2
(There is no this PGM in VAP2xx, VAP3xx)
Off
* 2 0 #
On
* 2 1 #
PGM3
(There is no this PGM in VAP2xx, VAP3xx, VAP404)
Off
* 3 0 #
On
* 3 1 #
Note:
If there is a PGM relay output module is connected to your system, you need
to enter PGM number (up to 8) after you enter "*" on the phone.
When you call your system, you may get information from your system about its
current status as follows.
Enter to the master program
[Enter] (Program) key long until you hear a long beep.
[Enter] your 4 digit master code.
[Enter] Panel Settings/Remote Access/Remac Options by using arrow keys.
[Enter] Option 1 to enable this feature as shown in below table.
[Enter] (Ok) key.
[Enter] Panel Settings/Remote Access/Ring Count by using arrow keys.
[Enter] Ring time.
[Enter] (Ok) key.
[Press] “*” button on the phone
[Enter] Your 4 digit user code. (If valid code is entered, panel sends short melody)
[Enter] Your commands according to the following table.
Summary of Contents for VAP Series
Page 1: ...VAP Series Alarm System User s Manual Issue Date 13 02 2007 TD 1 07 002 ...
Page 33: ...BD 1 07 002 32 ...
Page 34: ...BD 1 07 002 33 ...
Page 35: ...BD 1 07 002 34 ...
