TWM-1885 ANALOGUE ADDRESSED WIRELESS COORDINATOR
–
R01
TWM-1885 ANALOGUE ADDRESSED WIRELESS COORDINATOR
–
R01
3
3
Installation
Under this topic, the installation of TWM-1885 Addressed Wireless Coordinator module will be
explained step by step in details. Please read all steps carefully.
3.1
Mounting
The following articles must be followed carefully in order to provide a good communication with the
devices connected to the coordinator:
•
Choosing a proper communication channel will make the communication between the devices
more stable. Channel selection can be made automatically or manually. If manual selection is
to be made, initially all transmissions in the environment must be detected with the RF-
analyzer and according to this, relatively the most available channel must be preferred. See
programming section for manual channel selection.
•
The environmental factors such as high current lines, big metal objects, computers, network
lines, other cable lines, etc. that may interrupt the connection with the devices on the wireless
network must be avoided.
•
There must be at least 2 meters of distance from other wireless devices.
•
If possible, it must be mounted at least 2 meters high from and parallelly to the ground. The
antenna must remain at an angle of 90 degrees to the ground.
•
It must be operated under the proper ambient conditions indicated in technical specifications.
Otherwise, the operating performance will be affected.
•
A suitable location must be preferred by considering the communication distance when all
devices to be communicated are taken into consideration. Communication distance can be
seen in technical specifications.
The mounting holes of the module are located under the module cover. In order to access those, the
cover must be opened by gently pushing through the holes on the right side of the module by using a
flathead screwdriver.
3.1.1
Cable Holes
The holes through which the cables necessary for module connection will pass must be prepared
before wall mounting. For this purpose, holes must be broken open on the round points marked on
the product housing. Before breaking open the holes, the cards inside of the module must be removed.
The tabs holding the cards must be pulled gently in order to remove the cards.
