1
TFCM-1801
Programming Unit
USER MANUAL
Issue Date: 28 / 09 / 2017 R:02
General Information
TFCM-801 programming module is developed to read
and write the parameters of the terminal units such as
TFP-12XX series addressable detector, input-output
modules.
User friendly menu interface and controls provide easy
to use.
Usage areas:
•
Read existing addresses of the end units and
change their addresses
•
Read versions of end points.
Technical information
Battery Type
: 9V ( 6LR61 )
Operating temperature
: -
10°C / +50°C
Weight
: 95,2 gr (without battery)
Battery Assembly
A 9V battery is required for operation of the
programming module (provided with the product). The
battery supplied for the first time must be installed
correctly. Steps for installing the battery:
1)
Remove the battery case cover at the back of
the box.
2)
Connect connector correctly
3)
Install in the battery socket
4)
Close the cover
After this, the programming module is available.
DEVICE PROPERTIES
Teknim analog analogue addressable systems endpoints have a pair of 4-wire female to 8-pin connectors for
control via the programming module. The data exchange of the endpoint is done via this connector.
Caution: Do not leave the endpoints plugged
into the programming module, which will cause
the battery to run out quickly.
Button
Function1 (Menu)
Function2 (in the submenu)
Additional function
Enter (Green)
(
1
)
- Access sub-menu
- Confirm
- Refresh the value on the screen
-
Back (Red)
(
2
)
- Back to top menu
- Exit the menu
- Close programming module
(long press)
- Run the programming module
Up (Blue)
(
3
)
- Show previous menu
- Increase count (during write operations)
- Reset screen (during reading)
-
Down
(Blue)
(
4
)
- Show next menu
-Decrease count (during write operations)
-
