C
L E A R
P
A T H
- S C
U
S E R
M
A N U A L
R
E V
.
1 . 3 6
1 0 3
T
EKNIC
,
I
NC
. T
EL
.
(585)
784-7454
POWER4-HUB
S
PECIFICATIONS
24V power input (aux. power supply)
Specified voltage range:
20VDC to 30VDC
Absolute maximum input voltage:
40 VDC
Current draw:
400mA Max.
Connectors:
2-pin Molex MiniFit Jr. (P7, P8)
A labeled green LED on the board will light when 24V power is connected.
75V power input (motor bus power)
Specified voltage range:
20VDC to 90VDC
Maximum input voltage:
100VDC
Continuous current draw:
20A
10-second current draw:
60A
Connectors:
2-pin Molex Sabre (P5, P6)
Power outputs to ClearPath motors
Max
motors:
4
Connectors:
2-pin Molex Sabre (P1, P2, P3, P4)
Short-circuit protection
Actively protects connected power supplies from short-circuit/overload damage.
No reset or fuse replacement is necessary after a short-circuit or overload
incident.
A labeled red LED on the board will light when short-circuit protection is
activated.
Over-temperature protection
Thermal overload protected (activates at 105C, deactivates at
95C).
A labeled red LED on the board will light in an over-temperature condition.
Under voltage shutdown protection
Upon loss of motor bus power, the Power Hub will automatically switch over to low-voltage aux.
power to keep ClearPath communications and position tracking online.
A labeled red LED on the board will light in a motor bus under voltage condition.
Auxiliary overload protection
Aux. overload threshold
1.0A
If an aux. overload event occurs while aux. power is active, the aux power supply will shut down
until the 24V supply is power cycled.
A labeled red LED on the board will light (and remain lit) when an aux. overload condition
occurs.
Dimensions:
L x W x H (w/o plate)
3.92" x 3.09" x 0.95"
Country of Origin:
USA
Warranty:
1
year
