Cleaning the Toolslide
If the toolslide becomes hard to move and
adjust, cleaning and lubricating are required.
1.
To make the toolslide slide more freely
along the bed, make sure the bed rails are
clean. Apply some paste wax to the rails.
2.
If the toolslide is hard to move towards or
away from you, remove the toolslide from
the lathe bed. Clean the toolslide
camshaft (round eccentric rod) with a
petroleum-based solvent. Lubricate the
rod with a light-weight oil or a silicone
spray.
3.
Slide the base back onto the lathe bed.
Cleaning the Tailstock
If the tailstock quill becomes hard to use or
the Handwheel is hard to turn, cleaning and
lubricating are required.
1.
Remove the 6mm grub screw from the
tailstock. If necessary, turn the
Handwheel (to 12 o'clock) to expose
the set screw. You will see a hole in
the face of the handwheel that gives
access for an Allen key/wrench. A
3mm A/F (across flats) Allen key is
required (not supplied).
2.
Using a screwdriver, remove the
keeper plate from the tailstock body.
3.
Remove the quill and Handwheel from
the tailstock body.
4.
Wipe clean all parts including the
inside of the tailstock.
5.
Lubricate the quill and tailstock slot
with a light-weight oil and apply a small
amount of grease to the quill threads.
6. Reassemble.
Maintenance of the Motor
Keep the motor free of saw dust and wood chips especially around the fan housing.
Periodically check for any abnormal noise or excessive heat.
The Brushes should be checked every five years and replaced when brush length is less than
6mm (1/4").
For motor or electronic problems the machine should be taken to the nearest service center. See
the contact details at the front of this catalogue. In USA contact Woodcraft 1-800-535-4486.
22