Teka TS 138, Instruction Manual

Page: 22 / 53

Installation
Installation Location
The appliance should be set up in a well-ventilated, dry room.
Energy use and efficient performance of the appliance is affected by the
ambient temperature.
The appliance should therefore not be exposed to direct sunlight;
Do not be installed next to radiators, cookers or other sources of heat;
only be installed at a location whose ambient temperature corresponds
to the climate classification, for which the appliance is designed.
The climate classification can be found on the serial plate, which is
located at the left on the inside of the appliance.
The appliance must be positioned so that the plug is accessible.
The following table shows which ambient temperature is correct for
each climate classification:
Climate classification For an ambient temperature
SN
N
ST
T
+10 to +32
℃
+16 to +32
℃
+16 to +38
℃
+16 to +43
℃
If the refrigeration appliance is installed next to another refrigerator or
freezer a clearance of 5 cm at the sides is required, in order to prevent
the formation of condensation on the outside of the appliance.
Your refrigerator needs air .
For correct operation this appliance must be located in a dry
atmosphere, away from heat sources, e.g. cookers, radiators, boilers
and direct sunlight.
You should also ensure that air can circulate freely around the back and
the top of the cabinet. There should be 100mm between the top of the
cabinet and any overhanging kitchen furniture.
Alternatively allow 50mm between the top of the cabinet and any
overhanging kitchen furniture and a gap of 25mm on either side of the
appliance.
Reversing the door
The side at which the door opens can be changed from the right
side(as supplied) to the left side, if the installation site requires.
21