BIFORE CLEANING AND MAINTENANCE, BE
SURE THAT THE APPLIANCE IS DISCONNEC-
TED FROM THE MAINS SUPPLI.
•
Open the filter suppor t by moving the
closures.
Remove the support: take special care to
avoid dropping it.
•
Remove the filter by pulling it out and pro-
ceed with cleaning, either in a dishwasher
or leaving it under hot running water, clea-
ning it with a non-abrasive brush.
•
It should be dried once cleaning is
completed.
NOTE:
Cleaning in a dishwasher with strong
detergents may darken the metallic surface
without affecting its grease retaining perfor-
mance.
WARNING:
Filter cleaning should be carried
out at least once a month, depending on the
extent of hood use.
It should be remembered that grease accu-
mulates in the hood and in the filters even
though it is not switched on.
•
Soapy water at a temperature of about
40ºC is recommended. A damp cloth is
used with this water for cleaning the hood,
paying particular attention to crevices. It
should then be dried using a dry cloth that
does not leave any fibres.
WARNING:
•
Never use metallic scourers.
•
Do not use abrasive products that may
damage the metallic surface.
•
Do not scratch with hard objects such as
knives, scissors, etc.
The activated carbon filter cannot be washed
or regenerated. Once it has become soiled
(obstructed) it must be replaced (A).
Wait for the motor to cool before carrying out
this operation.
•
Remove the screw that holds the grill to
the support.
•
Turn the grill in an anticlockwise direc-
tion.
•
Using a pair of pliers, situate the ventila-
tor bolt over the axle.
•
Clean the grill and ventilator and then dry
them.
•
To fit the ventilator, place the axle in the
bolt as far as it will go and then press it
in.
•
Fit the grill by turning it clockwise.
WARNING:
The hood should never be switched on without
the grill. Non-compliance with this warning
shall be the sole responsibility of the user
when faced with a damaged appliance.
•
Remove the filter support to access the
light bulbs (B).
•
Make sure that the hood has previously
been disconnected from the mains
supply and that the bulbs to be replaced
are not hot.
•
The maximum bulb power is 40 W.
9
Cleaning the grill and ventilator
Changing the light-bulbs
Cleaning and maintenance
8
B
B
Limpieza del Filtro
Cleaning the filter support
and the hood body
Carbon filter
