Tefcold EXPRESS EX125C, Instruction Manual

Page: 56 / 59

10.7 Power Supply
All power supply cables must be correctly sized by competent
personnel, fitted correctly and be manufactured from materials
suitable for the application.
Cable connection points must be properly isolated in order to prevent
sparks. All electrical equipment must be fitted with adequate Earth
protection cables and all cables must be suitably identified.
Before starting installation of electricity, be sure that main switch is OFF
or main supply is DISCONNECTED.
Electric box and main isolator switch is located on the bottom of the cabinet.
Do not need to remove front fascia panel in order to reach the
controller and the isolator switch.
10.8 Prolonged Cabinet Switch-Off
▪
Remove the product contained in the cabinet and put it
immediately in a relevant cold storage container in order to
guarantee correct preservation.
▪
Open the cabinet and wait for it to reach room temperature and then clean
it.
▪
Leave the doors open by 2-3 cm so as to guarantee circulation of
the air and prevent the formation of mould and bad smells inside
the cabinet.
▪
The cabinet, with or without the packaging, should be carefully
tored inside warehouses or in areas away from the elements and
direct sunlight, at a temperature between 0 and +40