Owner’s manual
10
EN
1. Grasp the water tank (press the release button under the tank’s handle at the front of the
capacity of water tank is 1,2 l, the water level shall not be exceeded the MAX mark.
2.
cap, place the tank in its original place.
3. Put the iron on the thermal insulating cushion.
4. Connect the device to power mains. The device will issue one beep. Then press the power
button, the power indicator will be illuminated, and the low steam level indicator, regarded
as default one, will blink. User can select other steam level settings by pressing the steam
level control button according to requirement. After selection, corresponding indicator will
blink. Make sure that there is enough water in the tank.
5. Turn temperature dial to your desired setting, which is depended on the fabric of garment,
and temperature indicator will illuminate while heating up.
6. The water in the tank will be heating up. After few minutes, the temperature indicator will
be extinguished, which indicates the soleplate temperature has achieved the selected
temperature. And when the indicator of selected steam level has been changed from
blinking to constant light, it indicates you can take out of the iron and iron the garment with
steam function.
Caution:
• Do not touch hot soleplate at any time before cooling down!
• Don’t emit the steam directly on people or animals!
7. During operation, if the steam burst button is pressed and hold, but there is not enough
water in the tank, the water shortage indicator will be illuminated within 1 minute while the
button is held pressed. It prompts to add water into the tank. User should detach the water
8.
Disconnect it from power supply mains.
Vertical ironing
IMPORTANT:
Never attempt to perform vertical ironing of fabric a person is wearing! Do not
apply steam near or on a person!
Use the function on hanging fabric: hold the iron in vertical position and press and hold the steam
burst button to emit continuous steam. Bring close the iron’s soleplate to the fabric and move it
slowly over the material.
WARNING:
the soleplate after operation will be hot. Never touch it with bare hand! Place it
on the thermal insulating cushion until it cools down completely.
Note:
if there is no steam sprayed out from the soleplate within 10 minutes, the appliance
USING YOUR STEAM STATION IRON
