APPENDIX
DynaJet
®
Flex 7140
INITIAL ST
AR
TUP
MENU OPTIONS
INTR
ODUC
TION
13
98-05345-EN R2
OPER
ATION
NOZZLE MODES
There are two types of Nozzle Modes: Either is available in all
work modes.
Dual/Single Nozzle Mode – Select between the
use of single solenoid or dual solenoid.
Single Nozzle Mode – Only the use of single solenoid
will be available.
Dual/Single Nozzle Mode
Select between the use of single solenoid or dual solenoid.
To select an nozzle mode:
1. Press the CHANGE NOZZLE MODE button .
Figure 3-7: Work Screen – Dual Nozzle Mode
Active Solenoids
Change Nozzle Mode
Dual Nozzle Active – Indicates the droplet size is
included in calculating the target pressure; Press to
disable the droplet size
W
Information Bar will display both a blue dot and a
green dot.
Single Nozzle Active – indicates the droplet size is not
included in calculating the target pressure; Press to
enable the droplet size
W
Information Bar will display only a blue dot.
Single Nozzle Mode
Only the use of single solenoid will be available.
Figure 3-8: Work Screen – Single Nozzle Mode
