DynaJet
®
Flex 7140
OPER
ATION
MENU OPTIONS
INTR
ODUC
TION
APPENDIX
6
www.teejet.com
INITIAL ST
AR
TUP
NO. 2 SETUP UP MACHINE
When initially setting up the system, setting parameters for Units,
Number of Sections, Number of Nozzles, and Maximum Pressure
Sensor Value is strongly suggested. Selections are automatically
saved when adjusted. Other console settings, machine settings
and user parameters can be adjusted as needed after calibrating
the system.
1. From the Work screen, access the
Menu Options
.
2. Press the SETUP button .
3. Establish:
X
Units – Sets the units to US (psi) or Metric (bar).
X
Number of Sections – Set the number of boom sections.
This should match the number of sections used on the spray
controller.
X
Number of Nozzles – Set the number of nozzles for each
section. This value should match the number of nozzles
used on the spray controller. When programming is
complete, values should match and show in green.
X
Maximum Pressure Sensor Value – Verify this value by
looking at the pressure sensor description. Values will be
either 10 bar or 25 bar.
Figure 2-2: Setup
Previous/Next Page
Change V
alue
to Work Screen
NO. 3 SETUP UP AND SELECT NOZZLE
Accesses the nozzle selection process to select which nozzle is to
be used. At this time only TeeJet nozzles are supported.
1. From the Work screen, access the
Menu Options
.
2. Press the NOZZLE SELECTION button .
3. Using the GREEN UP/DOWN arrows , highlight a Nozzle
Series.
4. Press the NEXT PAGE button .
5. Using the GREEN UP/DOWN arrows , highlight the
Nozzle Capacity.
6. With the correct nozzle capacity highlighted, select the HOME
button to return to work mode.
The selected nozzle will be active and will automatically be added
to the Favourites List .
Figure 2-3: Nozzle Selection
