87
98-05304-EN R2
Aeros 9040 field computer
HOME
SE
TUP
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
GUID
ANCE
BOOMPILOT
Depending on if there is a section control system present and when
present what kind of section control is being used as well as what
options are enabled, there are multiple options for BoomPilot section
control.
This section includes setup options for these configurations:
►No Section control module
● Console only
● With optional work on/off switch
►ISOBUS sprayer
● Console and ECU only
● With switchbox
● With an ISOBUS implement status module (ISO ISM)
►ISOBUS spreader
● Console only
● With optional spreader on/off switch
►With TeeJet Section control module and switchbox or ISM
►With TeeJet Section control module
Figure 7-31: BoomPilot icon and Status bar indicator
0.0
km/h
0.00
ha
Mark A
No Section control module
If a section control system is not present, the BoomPilot icon or an
optional work on/off switch is used to turn the single section on or off.
Only one section width will be illustrated and the status bar will have
no icon.
NOTE: If an ISOBUS controller, SmartCable, Section driver module
(SDM), or Switch function module (SFM) is present, please
refer to the following sections for more information.
NOTE: The BOOMPILOT icon is grey
when GNSS is
unavailable.
Console only
The BoomPilot icon is used to turn the section on or off.
To set configuration settings:
1. Press SYSTEM SETUP bottom tab
.
2. Press CONFIGURATION side tab
.
3. Press
Implement
.
4. Set “BoomPilot icon” to
Enable
.
NOTE: BoomPilot start mode setting will make no difference in the
function of this option.
To switch application off or on using the console:
1. Press NAVIGATION AND GUIDANCE OPTIONS tab
to
display navigation options.
2. Press BOOMPILOT icon .
3. Press BOOMPILOT icon to toggle the section on or off.
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
