52
www.teejet.com
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
IMPLEMENT
Figure 6-14: Single section
Figure 6-15: Distances and length
Figure 6-16: Lateral offset direction and distance
– Centre of the GNSS antenna
– Antenna to disks in-line offset distance
– Implement lateral offset direction/distance
– Spread offset distance
– Spread length
Multiple sections
Section control is available (SmartCable, Section driver module
(SDM), or Switch function module (SFM) or ISOBUS).
1. Select
Spreader
implement type on Implement screen.
2. Press Implement type NEXT PAGE arrow
.
3. Select from:
►Setup type – used to select
TeeJet
spreader type
►Antenna to disks in-line offset distance
– measured in
parallel to the centreline of the machine, defines the in-line
distance from the GNSS antenna to the disks, or dispersal
mechanism
►Implement lateral offset direction
– defines the lateral
direction, either left or right, from the centreline of the machine
to the centre of the implement while facing in the machine's
forward direction
►Implement lateral offset distance
– defines the lateral
distance from the centreline of the machine to the centre of
the implement
►Overlap – used to define the amount of overlap allowed when
using automatic boom section control
►Delay on time – used to set the time when the section will
switch on when entering an area that has not been applied
NOTE: If the application turns on too soon when entering
an unapplied area, decrease the Delay on time. If the
application turns on too late, increase the Delay on time.
►Delay off time – used to set the time when the section will
switch off when entering an area that has been applied
NOTE: If the application turns off too soon when entering
an unapplied area, decrease the Delay off time. If the
application turns off too late, increase the Delay off time.
►Spread offset distance
– used to set the distance between
the disks or dispersal mechanism and where product initially
hits the ground on section 1.
►Section offsets
– used to set the offset distance from
section 1 (the Spread offset line) to the leading edge of each
section. section 1 is always 0. All other sections can be
different distances.
►Section lengths
– used to set the length of application in
each section. Each section can be a different length.
NOTE: Sections are numbered from left to right while facing
in the machine's forward direction.
4. Press RETURN arrow
to return to the Implement screen
or CONFIGURATION side tab
to return to the main
Configuration screen.
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
