50
www.teejet.com
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
IMPLEMENT
Figure 6-9: Overlap
100%
50%
0%
Multiple sections with ISOBUS sprayer setup
Section control is available (ISOBUS). See "ISOBUS Sprayer
Offsets" in this chapter for more details.
1. Select
Straight
implement type on Implement screen.
2. Press Implement type NEXT PAGE arrow
.
3. Select from:
►Connection point in-line offset direction
– establishes if
reference point is located in front of (forward) or behind
(backward) the GNSS antenna while facing in the machine's
forward direction
►Connection point in-line offset distance
– measured in
parallel to the centreline of the machine, defines the in-line
distance from the GNSS antenna to reference point
►Connection point lateral offset direction
– defines the
lateral direction, either left or right, from the centreline of the
machine to the centre of reference point while facing in the
machine's forward direction
►Connection point lateral offset distance
– defines the
lateral distance from the centreline of the machine to the
centre of reference point
►Implement in-line offset direction
– displays if the
implement is located in front of (forward) or behind (backward)
the GNSS antenna while facing in the machine's forward
direction
►Implement in-line offset distance
– measured in parallel
to the centreline of the machine, displays the in-line distance
from the GNSS antenna to the implement
►Implement lateral offset direction
– displays the lateral
direction, either left or right, from the centreline of the machine
to the centre of the implement while facing in the machine's
forward direction
►Implement lateral offset distance
– displays the lateral
distance from the centreline of the machine to the centre of
the implement
►Overlap – used to define the amount of overlap allowed when
using automatic boom section control
►Delay on time – used to set the time when the section will
switch on when entering an area that has not been applied
NOTE: If the application turns on too soon when entering
an unapplied area, decrease the Delay on time. If the
application turns on too late, increase the Delay on time.
►Delay off time – used to set the time when the section will
switch off when entering an area that has been applied
NOTE: If the application turns off too soon when entering
an unapplied area, decrease the Delay off time. If the
application turns off too late, increase the Delay off time.
4. Press RETURN arrow
to return to the Implement screen
or CONFIGURATION side tab
to return to the main
Configuration screen.
Figure 6-10: Implement offset directions and distances
Figure 6-11: Connection point offset directions and distances
– Centre of the GNSS antenna
– Reference point
– Implement in-line offset direction/distance
– Implement lateral offset direction/distance
– Connection point in-line offset direction/distance
– Connection point lateral offset direction/distance
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
