49
98-05304-EN R2
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
IMPLEMENT
Figure 6-6: Implement offset directions and distances
– Centre of the GNSS antenna
– Implement in-line offset direction/distance
– Implement lateral offset direction/distance
Multiple sections with SDM or SFM
Section control is available (SmartCable, Section driver module
(SDM), or Switch function module (SFM)).
1. Select
Straight
implement type on Implement screen.
2. Press Implement type NEXT PAGE arrow
.
3. Select from:
►Implement in-line offset direction
– establishes if the
implement is located in front of (forward) or behind (backward)
the GNSS antenna while facing in the machine's forward
direction
►Implement in-line offset distance
– measured in parallel to
the centreline of the machine, defines the in-line distance from
the GNSS antenna to the implement
►Implement lateral offset direction
– defines the lateral
direction, either left or right, from the centreline of the machine
to the centre of the implement while facing in the machine's
forward direction
►Implement lateral offset distance
– defines the lateral
distance from the centreline of the machine to the centre of
the implement
►Overlap – used to define the amount of overlap allowed when
using automatic boom section control
►Delay on time – used to set the time when the section will
switch on when entering an area that has not been applied
NOTE: If the application turns on too soon when entering
an unapplied area, decrease the Delay on time. If the
application turns on too late, increase the Delay on time.
►Delay off time – used to set the time when the section will
switch off when entering an area that has been applied
NOTE: If the application turns off too soon when entering
an unapplied area, decrease the Delay off time. If the
application turns off too late, increase the Delay off time.
4. Press RETURN arrow
to return to the Implement screen
or CONFIGURATION side tab
to return to the main
Configuration screen.
Figure 6-7: Multiple sections
Figure 6-8: Implement offset directions and distances
– Centre of the GNSS antenna
– Implement in-line offset direction/distance
– Implement lateral offset direction/distance
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
