47
98-05304-EN R2
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
IMPLEMENT
CHAPTER 6 – IMPLEMENT SETUP
Implement setup is used to establish the various settings associated with straight mode, spreader mode, and staggered mode.
Settings will vary depending on if there is section control available (SmartCable, Section driver module (SDM), or Switch function
module (SFM) or ISOBUS) or if there is an ISOBUS rate controller on the system.
Multiple section output modules
Multiple section output modules may be installed on the CAN bus to
allow more sections than a single module allows. If a section control
module is on the system, the settings for Multiple section output
modules should be set up first.
1. Press CONFIGURATION side tab
.
2. Press
Implement
.
3. Press Multiple section output modules NEXT PAGE arrow .
4. Press
Refresh
.
5. Press DOWN arrow and assign the correct Module ID to the
sections.
6. Press
Activate modules
.
7. Press RETURN arrow
to return to the Implement screen
or CONFIGURATION side tab
to return to the main
Configuration screen.
Figure 6-1: Setup options for multiple section output modules
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
