23
98-05304-EN R2
Aeros 9040 field computer
HOME
GUID
ANCE
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
SE
TUP
Nozzle flow monitor
When a nozzle flow monitor kit is present, nozzle flow monitor
options are used to configure flow limits and alarm behavior, and to
run the nozzle flow balance process.
NOTE: For detailed setup instructions, refer to the supplemental
Nozzle flow monitor (TFM) guide.
1. Press CONFIGURATION side tab
.
2. Press
Nozzle flow monitor
.
3. Select from:
►Nozzle alarm percentage – used to set the error reporting
range for the nozzle sensors
►Nozzle alarm delay – used to set the time the console will wait
after an error has been encountered before sounding a nozzle
alarm
►Number of sections – used to set the number of sections
►Number of tips per section – used to enter the number of tips
on the specified section
►Nozzle balance percentage – used to set the range for
balancing nozzle sensors
NOTE: The implement must be in a job and all sections must
be on to start the nozzle balance process.
►Nozzle flow monitor balance – used to start the nozzle flow
balance process
4. Press RETURN arrow or CONFIGURATION side tab
to
return to the main Configuration screen.
Figure 4-22: Nozzle flow monitor options
ISOBUS
When ISOBUS is in use, the ISOBUS page is used to select
information for broadcast over the ISOBUS, and to verify specific
information in troubleshooting.
1. Press CONFIGURATION side tab
.
2. Press
ISOBUS
.
3. Select from:
►Machine speed broadcast – used to broadcast speed
information provided by the machine over the ISOBUS
►Navigation speed broadcast – used to broadcast speed
information provided by the machine over the ISOBUS
►Ground speed broadcast – used to establish if the GNSS
speed shall be broadcast as Ground based speed on the
ISOBUS from this console.
►Time/date broadcast – used to broadcast time and date over
the ISOBUS
NOTE: Normally these shall be enabled, but if an alternative
speed source shall be used, then it might be required to
disable the GNSS speed, to ensure that the alternative
speed source will be used by the ISOBUS controllers.
4. Press RETURN arrow or CONFIGURATION side tab
to
return to the main Configuration screen.
Figure 4-23: ISOBUS options
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
