12
www.teejet.com
Aeros 9040 field computer
HOME
GUID
ANCE
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
SE
TUP
CONFIGURATION
Configuration is used to configure the system components including
implements, guides, steering, monitors and sensors.
NOTE: Feature availability will vary depending on the devices
available and unlocked on the Aeros 9040 system.
1. Press SYSTEM SETUP bottom tab
.
2. Press CONFIGURATION side tab
.
3. Select from:
►Implement – used to set (as appropriate) machine type,
GNSS antenna height, implement type, symmetric implement
layout, section output modules, number of implement
sections, application/working width, droplet size monitor,
nozzle selection, nozzle spacing, BoomPilot start mode,
reverse sense module
● In Straight mode – in-line/lateral implement offset direction/
distance, overlap percentage, implement delay on/off time
● In Spreader mode:
TeeJet – antenna to disks distance, lateral implement offset
direction/distance, overlap percentage, delay on/off times,
spread offset distance, section offset distances, section
lengths
OEM – antenna to disks distance, lateral implement offset
direction/distance, start/stop distance, section start/stop
offset distances
● In Staggered mode – in-line/lateral section 1 offset
direction/distance, overlap percentage, delay on/off times,
section offsets
►Mapping and guidance – used to configure the mapping
location, guidance width, guidance sensitivity (cross track
error) and/or an optional external lightbar module (ELM)
►GNSS – used to establish GNSS type, port, and PRN, as well
as to view GNSS status information
►Video – used to set up individual cameras
►Sensors – used to establish pressure sensor settings
►Nozzle flow monitor – used to establish nozzle configuration,
and to establish and calibrate flow limits and alarm behavior
for nozzle flow monitors
►ISOBUS – used to select information for broadcast over the
ISOBUS, and in troubleshooting
►Product – used to configure product name, tank/bin volumes,
target application rates, increment for adjusting target rates,
and colour mapping maximum/minimum rate limits and
corresponding display colours
►AutoSteer – used to enable/disable and calibrate assisted/
auto steering
● FieldPilot – used to establish valve setup settings, steering
settings, steering wheel and steering angle sensor settings,
and to perform valve tests or valve diagnostics
● FieldPilot Pro / UniPilot Pro – used to manage vehicle
settings, calibrate sensors, select QI values, as well as
establish transport mode and service mode
►Tilt correction – used to enable/disable and calibrate the tilt
correction function, and improve application on hilly or sloped
terrain
Figure 4-2: Configuration options
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
