Operation Manual Multichannel Transmitter SKJ22/44MR
The SKJ22MR or SKJ44MR hand transmitters are part of the Teletaster® K512 product range
and can learn 2 or 4 independent codes from another (mother) transmitter.
Attention:
For adjustments on the transmitter disconnect the power plug of the receiver. Risk of accident!
Learn of X-code:
1. To learn, hold the mother transmitter with the antenna to the learn detector (not use a table
with metallic ground).
2. On the SKJ22 / 44MR, keep buttons 1 2 pressed simultaneously for at least 3 seconds (LED
flashes to confirm after 3 seconds), then release buttons.
3. Master transmitter: Press the key from which the coding is to be taken and keep it pressed.
4. On the SKJ22 / 44MR press the key to which the coding is to be transferred (approx. 1sec,
LED flashes to confirm)
5. Release the buttons on both transmitters.
6. Repeat the programming from point 1 to learn another coding
Service:
1. Press the operating button ; when the LED is lit the battery is still good and the transmission
is done.
The device corresponds to the technical European regulations Community,
carries the CE sign and can in all EU states and Switzerland to be used
without registration. The declaration of conformity for the devices see
Do not throw old devices and batteries into the trash!
Control buttons (depend on modell 2 or 4)
LED, lights upon actuation of a control key, when
the battery is still good.
Learn detector
Battery, type CR2032: for change the battery Open the
back of the transmitter on the metal bracket with a coin.
1
1
2
3
4
3
1