21
l
Means the ambient room humidity is higher than 80%.
11.
Compressor is in progress. In case the de-frost function is working, the water
drops will flash.
Compressor is not in progress.
Water full.
12.
Heat indicator: While you press the heat button and the ambient temperature is lower
than 25
o
C, the heat indicator will light on and the heater will work. At this time, the
fan speed will keep at high speed only. However, if the ambient temperature is higher
than 25
o
C, the heat indicator will not light on and the heater will not work, either.
*
This PTC heater is protected by thermostat & thermal fuse for overheat protection.
13.
UV ( ultraviolet ) indicator, only for the model with UV light. * UV can kill the
bacteria in the air.
14.
Timer indicator, 1 to 24 hours.
15.
Room temperature indicator, can display the room temperature in Celsius degree (
o
C)
by pressing “HUM” button at least 2 seconds.
16.
Fan speed/ventilation indicator:
high speed,
low speed.
Operation
1.
Plug the unit into a correct mains socket. (Please refer to the rating label at the rear of
the unit.)
2.
Press button ON/OFF to turn on the unit. The compressor will start to work in
continuous mode.
3.
Press button HUMIDITY to set the room humidity you need: continuous
de-humidifying , 50%, 60%, 70% or 80%
4.
Press the speed button to choose the ventilation speed, high or low.
5.
To turn off the unit, press button ON/OFF again.
6.
The direction of the air outlet can be adjusted by hand.
