ISOBUS ECU 1224 User and Instruction maual
|
P00801545 Rev:02 SW:1.0.0
61
If the tank level sensor is not installed, the user shall manually specify the
new level of the tank. This may be done by pressing the
key that causes the showing of a
dialog box where the user can specify the new level. In case level sensor is installed, ISOBUS ECU
1224 automatically measure tank level
20.5 Ratio
The central part of the WORK page, contains a meter used to show the currently measured rate
and its desired setpoint (defined by user in manual mode or by TC in auto mode).
20.6 Change Rate
– Manual Mode
Increase current rate set-point (l/ha). Note this button is available only when manual mode
is active.
Decrease current rate set-point (l/ha). Note this button is available only when manual
mode is active.
20.7 Change Rate
– Automatic Mode
Check user manual of the Task Controller included in your Virtual Terminal.
20.8 Terminate treatment
Treatment will be closed and data stored in the Virtual terminal when you start a new treatment.
SETPOINT
CURRENT
VALUE
Summary of Contents for GEOline 8410073
