tecnoswitch CR035BI, Manual

Page: 42 / 64

10.3.4 Press or to set the desired correction value between -3 and + 3° C.
10.3.5 Press OK to confirm.
10.4 FROST PROTECTION FUNCTION
I’ts important to avoid damage caused by too low temperatures. This function works only in the
Heating mode. The default temperature is + 5° C. If the temperature drops below this
value the system starts working.
Set the desire temperature within a range from 2° C to 7° C.
10.4.1 Repeat the steps 10.1.1 al 10.1.4.
10.4.2 Press up to position on that it will start to flash.
10.4.3 Press OK to confirm. The set temperature flashes.
10.4.4 Press or to set the desired frost protection temperature. Fig.33