TS VIII PNEUMATIC MOTOR
6
✓
The presence of third parties in the work
area of the equipment should be
restricted as much as possible, thus
avoiding any impact on safety. For any
other use, an additional study of the
hazards derived from this way of
working must be carried out.
✓
It is important that the users who
operate this equipment are familiar with
and sufficiently trained to use this
product or similar products.
✓
In any case, the operator must read and
understand this manual before use
regardless of their knowledge, training
or experience with similar equipment,
especially the sections dedicated to
installation, operation and safety.
✓
For tasks regarding maintenance,
adjustment, cleaning, etc. there must be
the spaces necessary for these tasks.
✓
If you have questions about handling or
maintenance procedures, please contact
your
3arm®
and/or
Roscamat®
distributor.
2.3
EXCLUSIONS
The following is beyond the scope of use of
this equipment:
✓
Handling of any component or functions
of the equipment outside of those
specified in this manual.
✓
Use by people with some type of
disability or by animals.
✓
Use by people who have not completed
the occupational risk prevention course.
It should not be installed:
✓
Installation in corrosive areas.
✓
Installation in dusty areas.
✓
Installation
in
areas
with
high
electromagnetic emissions.
✓
Installation in areas with extreme
temperatures (very high or very low).
✓
Installation in areas with high humidity.
✓
Installation in outdoor areas.
2.4
DECLARATION OF INCORPORATION
Pursuant to the European Directive on
construction of machinery, the equipment is
considered quasi machinery. It can only be
commissioned
when
the
following
requirements are met:
✓
The equipment is integrated for a
specific application.
✓
The equipment is integrated with all
the safety functions and protective
devices necessary to be considered a
machine for a specific application,
pursuant to the European directive
for machine construction.
✓
Once integrated, it complies with the
requirements
of
the
European
directive for machine construction,
which is proven with a conformity
assessment process.
✓
The integrator/end user must draft an EC
statement of compliance pursuant to the
applicable machinery directive.
2.5
SYMBOLOGY AND ICONS
Throughout this manual and on the machine
structure, different symbols and pictograms
can be observed, the meanings of which are
summarised below.
