T-44/48 Series Operation Manual
33
T-44/48 Series | rev.
firm. 1.258 and above
The live measured impedance value is also shown on the Driver page. Since the device
can only measure this when there is a signal, the impedance is indicated as “?” when there is
insufficient signal level to perform a measurement.
4.4 Utility Page
4.4.1 Screen Contrast
The Screen page in the “
UTILITY
” section adjusts the contrast (and optimal viewing
angle) of the screen from 0-100% in 1% increments.
4.4.2 Stereo Linking
Stereo linking is available between DSP Drive Modules A & B and between C & D.
Changing a parameter in either of the stereo linked Drive Modules will change the other linked
Drive Module. Stereo linking is controlled by the
STEREO
page in the “
UTILITY
” menu.
Note:
Stereo linking state is not stored in Presets (but is stored in Snapshots).
4.4.3 Current Ethernet IP Address
This may be viewed in The
“IP Curr
” page of the “
UTILITY
” menu. This value cannot be
edited.
4.4.4 IP Mode
The Ethernet IP address may be automatic “
Auto
” or may be a fixed static value
“
Static
” as determined by the “IP Mode” page of the “
UTILITY
” menu.
WARNING – Do NOT use Static mode unless your IT system specifically requires it. Auto
mode should always be used where possible since in this mode, the T-44 amplifier can
always be ‘discovered’ by the
System Engineer
application. When in Static mode, a
warning will flash on the Default screen.
Also see Ethernet Configurations on page 41.
4.4.5 IP Static
This allows the Static Ethernet IP address to be adjusted by the three rotary encoders
on the IP Static page of the “
UTILITY
” menu. This will only have effect when in Static mode.
U
Screen
50%
U
IP
Curr
192.168
0
123
