Loudspeaker Configuration
13
IBZA Series | rev.
2.5
2.4 Rotating the Horn
You can easily re-orient the IBZA10 rotatable horn to its 70º x 50º configuration. To
rotate the IBZA10’s horn, perform the following steps:
1. Place the IBZA10 loudspeaker with the front grill facing up. Ensure that the working
surface is clean with a non-slip finish.
2. Remove the six (6) metal reinforcement profiles screws (three per side) from IBZA10
using a hex key.
3. Carefully remove the grille.
4. Release the four (4) screws of the horn using a hex key. Pull the horn and the
compression driver upward out of the loudspeaker enclosure, being careful not to over-
stress its wiring.
5. Check that the seal between the enclosure and horn is properly seated.
6. Rotate the horn carefully on the desired position and place the horn and driver back into
the cabinet. It will fit comfortably snug.
7. Replace the four (4) horn flange screws.
8. Carefully replace the grille cover and the two (2) metal reinforcement profiles with its six
(6) screws.
Summary of Contents for IBZA Series
Page 2: ......
Page 20: ...Operation Manual 19 IBZA Series rev 2 5 IBZA10 Dimensions ...
