Operation Manual
IBZA Series | rev.
2.50
10
1.5 Processing and Amplification
Only operate Tecnare loudspeaker with a correctly configured Tecnare preset. Tecnare
offer a complete solution that guarantees the highest level of performance. A complete range of
controllers, amplified and amplified controller with DSP are available to get this objective.
Otherwise, there is a risk of damaging the loudspeaker components.
1.5.1
Processing
There are two options using our digital controllers. The
DP2696
or
DP4896
are the
approved processor for use whit IBZA Series. The options vary depending on the final
application.
Refer to DP2696 or DP4896 user manual.
You may obtain the settings from the DP Series at
1.5.2
Amplification
To power IBZA Series, Tecnare recommends amplifiers with the power ratings enough
to feed the loudspeakers. For high power or live applications, it is recommended to
oversize the amplifiers relative to the nominal AES output of the loudspeakers. A lower
power amplifier will not reduce the chances of driver damage due to over-excursion,
and may actually increase the risk of thermal damage due to sustained clipping.
In certain specific cases it is possible to slightly under-power the subs or loudspeakers
as long as the amplifier will not be driven to its limits.
In any case, the Tecnare processors should be deployed in front of the amp to ensure
that the amplifiers to not go into clip.
The
TSeries
amplifier or
DP4896
processors also include:
- Virtual
X
over Limiter for passive systems
- Thermal protection from power surges or overload
-
Xmax
Excursion displacement protection
The
T10-44/T6-44
and
T-48 Series
amplifier is the ideal companions for maximum
performance of the IBZA Series loudspeakers. These
Advanced System Amplifiers
controlled
with DSP offer a complete both preset and protection solution for any application.
