Tecnam P2002 JF, Maintenance Manual

Page: 445 / 1289

Page 201 2
nd Edition – Rev 0
27-50
RUDDER –MAINTENANCE PRACTICES
1. RUDDER CONTROL CABLE REPLACEMENT
Step Task description
Additional info &
References
1. Engage parking brake
2.
Remove seats, central pad, tapestry and floor panel
Refer to Figure 7. and to
Chapter 12
3. Open (10) (7a) (7b) (8a) (8b) inspection caps Refer to Chapter 06
4. Remove panel (BC2) Refer to Chapter 25 tab. 8
5. In (8a) & (8b) inspection cap: cut safety wire, remove
cotter pin, bolt and washer. (pedals without brake pump
shown in figure, same process applicable at pedals with
brake pump).
Refer to Figures:
-
27. item A
- 28.
6. Unscrew completely turnbuckles to disconnect cable ends Refer to figs. 28 & 31
7. In (10) inspection cap unscrew and remove rudder/rudder
cables attachments:
- Remove cotter pin
- Remove bolt washers and nut
- Pull out cable from its attachment
- Remove from cable the terminal fig. X item B
Refer to Figures:
-
27 .item B
-
29.
-
31.
THESE STEPS ARE APPLICABLE TO LH AND RH RUDDER CABLE
8. Remove and replace (if required) rudder cables
9.
In (8a) & (8b) inspection cap join LH and RH control
cable to pedals; tighten according standard value,
lubricate with grease.
Refer to Figures:
-
27. item A
- 28.
See chapter 12 and 20
10. Drive cable trough pulley (rear panel BC2) Refer to figs. 30 & 31
11.
Join cable to terminal and terminal to rudder cables
attaching plate; tighten according standard value,
lubricate with grease.
Refer to Figures:
-
29
-
31
See Chapter 12 and 20
12. Check control cable tension; adjust turnbuckle and apply
safety wire. See Chapter 20 (See tension
values)
13. Check for interference between control cable and
structural components
14. Check rudder travel limits See Chapter 55
15. Close all inspection caps
16.
Install tapestry, floor panel and seats
Refer to Figure 7 and to
Chapter 12
17. Ensure that pedals movement is smooth and free
18. Ensure that rudder movement is smooth and free, and no
objects are left inside during replacement