SQICUGM-EN2 Rev. A
31
Removing the Cover from an External Drive
To gain access to the tape drive circuit board, remove the cover from the drive as
follows.
1.
Place the drive horizontally and upside down on a flat surface.
2.
Facing the front of the drive, remove the rubber foot closest to you on the left
side. Refer to Figure 10.
3.
Using a phillips screwdriver, remove the locking screw located under the
foot.
4.
Return the drive to its upright position, press in on the tab located on top of
the drive, and slide the drive forward and out of the drive cover.
To replace the cover, reverse this procedure.
qicaa.fm Page 31 Wednesday, April 23, 1997 6:07 PM
