Configuring converters / Connecting converters to PC
MasterCAN RS2CAN / CAN2RS data converters. Operation manual. Version 1.0
©
Technoton, 2020
25
3.2 Connecting converters to PC
ATTENTION:
Prior to connecting converter
to a PC, it is necessary to turn off
electrical circuits of the machinery unit (
*
. To do this, use the battery switch
or remove the battery terminals.
Before starting to use service adapter, have a closer look on its elements to detect defects
which can occur while service adapter was transported, stored or handled carelessly.
Avoid the following when connecting service adapter to converter, installed on the Vehicle:
•
ingress of fuel and lubricants and moisture to the contact pins of adapter slots or
connectors of service cables;
•
potential damage of the adapter and cables by the rotating and heating elements of the
engine.
The converters are connected to the PC for their configuration, in accordance with connection
diagrams, provided in figure 13. You need to perform the following operations in the following
sequence:
1)
. For this purpose, connect the adapter service cable
connector through to
K-Line
socket of the converter. The converter and adapter can be
powered through one of the free S6 SK connectors, through the converter
CAN
connector
or by power supply wires of the adapter service cable (see figure 13 a).
Note
—
During the configuration of a
converter and adapter are powered via S6 cable system (see figure 13 b).
2)
Connect the adapter with USB cable to a free USB-port of your PC.
Note
—
Adapter can also be connected to USB-port of your PC after turning electrical
system ON and starting the software.
3)
Connect power supply and ground wires to electrical system or battery.
4)
Power ON.
a) connecting MasteCAN CAN2RS/MasteCAN RS2CAN using S6 SK