16
Figure 14 Long backup external battery connection
a)
Install the base, then place the RT UPS on the base one by one as Fig.13 shows.
b)
The cover installation and cable connection of the UPS and EBPS are the same as
RT. (To install the optional EBP(s) for a UPS)
2-4
UPS start up and turn off
Start up operation
(1) Turn on the UPS in line mode
NOTE Verify that the total equipment ratings do not exceed the UPS
capacity to prevent an overload alarm.
a)
Once mains power is plugged in, the UPS will charge the battery, at the moment,
the LCD shows that the output voltage is 220, which means the UPS automatic
ally tart the inverter. If it is expected to change to bypass
model, you can Press
“OFF” key.
b)
Press and hold the ON key for more than half a second to start the UPS, then it
will start the inverter.
c)
Once started, the UPS will perform a self-test function, LED will light and go out
circularly and orderly. When the self-test finishes, it will come to line mode, the
corresponding LED lights, the UPS is working in line mode.
(2) Turn on the UPS by DC without mains power
a)
When mains power is disconnected, press and hold the ON key for more than half
a second to start UPS.
b)
The operation of the UPS in the process of start is almost the same as that when
mains power is in. After finishing the self-test, the corresponding LED lights and
the UPS is working in battery mode.
Turn off operation
(1)
Turn off the UPS in line mode
a)
Press and hold the OFF key for more than half a second to turn off the UPS and
inverter.
b)
After the UPS shutdown, the LEDs go out and there is no output. If output is
needed, you can set bps “ON” on the LCD setting menu.
