Adductor
14
C
B
A
Replacing the cable
Cables must always be replaced at the first sign of wear, even if only the outer
rubber protection is worn.
WARNINGS
Carefully check the state of the cables once a month.
ALWAYS use cables supplied directly by Technogym.
To replace the weight stack cable, you must:
- remove the protective panel covering the weight stack, following the
instructions found in the paragraph headed
Removing the front weight stack
panel
;
- unscrew the screws (
A
), back off the lock nut (
B
) and unscrew the adjuster (
C
);
- remove the weight stack cable from the adjuster side;
- insert the new weight stack cable from the adjuster side (ensuring that it
follows the same route as the original cable, as shown in the illustration);
- tighten screws (
A
), screw in adjuster (
C
), and screw on lock nut (
B
);
- refit the protective panel on the weight stack.
