Technogym Recline 600 XTPRO, Service Maintenance Manual

Page: 64 / 86

RECLINE 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 8.4
8.4. CHAIN TENSION
Figure 8.4-1
Carry out the procedures described in paragraphs
7.9. “Disassembling the right and left side
casings”
From both sides of the frame:
1. Back off the 2 screws
a which clamp cam b
to the frame, using a 4-mm hex T wrench.
2. Turn the cams in a clockwise or
anticlockwise direction to loosen or tighten
the chain, until the vertical play at point
A is
approximately 1 cm.
3. Check the amount of play at point A for
different pedal positions.
4. Lock down screws
a from both sides of the
frame.
After completing the procedure, check
the alignment of the chain as described
in paragraph 8.3. and check the belt
tension as described in paragraph 8.2.