Technogym Recline 600 XTPRO, Service Maintenance Manual

Page: 51 / 86

RECLINE 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 7.9
7.8. DISASSEMBLING THE HAND SENSORS
Figure 7.8-1
1. Turn off the machine and unplug the mains
lead from the wall output.
For each SENSOR:
2. Use a pointed tool (such as a screwdriver) to
leverage inside the SENSOR slot a .
3. Lift the upper SENSOR.
The sensors are attached to the
handlebar with adhesive tape.
Figure 7.8-2
4. Back off the 2 screws b using a small Phillips
screwdriver.
5. Allow the lower SENSOR to drop.
To facilitate separation of the 2
supports, it is possible to back off cap c
using a 6-mm hex T wrench.
6. To disconnect the SENSORS, disconnect the
Fastons of their fixing cables.
To reassemble the SENSORS, carry out the
above steps in reverse order.