Technogym Recline 600 XTPRO, Service Maintenance Manual

Page: 20 / 86

RECLINE 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 3.2
•
Non-coded : this is the standard product.
•
Coded : this is the product which, utilizing Personal Coded Device technology, receives the
heart rate together with a code that identifies the transmitter in question. In this way the machine
can identify the source of the heart rate signal, thereby avoiding interference problems.
Its reception area is approximately a circle of 1 meter of radius. If there is electromagnetic noise
(produced by high voltage lines, radio transmitters, monitors, motors, etc.) within its reception area,
the receiver becomes saturated and stops receiving any signal. If it is non-coded and there are 2
transmitters within its area of reception, it will receive signals from both, and may produce an error
or irregular reading.
CPU BOARD
This is the heart of the machine, which controls all the machine functions by executing the program
stored in EPROM. It receives information from the user (age, weight, etc.) during set-up of the
training session, from the cardio receiver and/or the HS interface board (user’s heart rate) and from
the alternator interface board for displaying workload data (Watt and RPM). It controls the difficulty
level selected with the “+” “
−
” keys or according to the chosen training program.
3.1.2. C
ARDIO TRANSMITTER
It is worn by the person using the machine, and transmits to the cardio receiver one pulse for every
heart beat that is detected. There are 2 types of transmitter:
•
Non-coded : this is the standard product;
•
Coded : this is the product which, utilizing Personal Coded Device technology, transmits the
heart rate together with a code that identifies the transmitter in question. In this way, the coded
receiver on the machine can identify the source of the heart rate signal, thereby avoiding
interference problems.
3.1.3. HS
INTERFACE BOARD
This circuit board manages the hand sensors, interfacing them to the CPU board. It processes the
analog signal received from the sensors and outputs one pulse for every heart beat detected, with
positive logic: the signal is normally at 0 Vdc, and is asserted to 5 Vdc (with a pulse whose
amplitude of approximately 30 msec) each time a heart beat is detected.
There are 3 jumpers on this circuit board, which must be configured as indicated in the table below:
Jumper Configuration
JP1 Open
JP2 Closed
JP3 Closed
3.1.4. RJ45-RS232
BOARD
This circuit board provides the machine connections to external devices:
•
1 serial port for connecting to the TGS reader;
•
1 serial port, currently not used, for future connections;
•
1 RJ45 port for the power supply to the portable Cardio Theater unit.