Dual Adjustable Pulley
4
Personal safety
Use of the unit is subject to a
medical examination
in relation to the type of workout exercise you intend to perform, and in compliance with the
conditions
for use
laid down by Technogym.
Before beginning a training plan, consult a doctor to ascertain any limitations to use of the equipment.
Persons suffering from certain physical conditions may only use the unit under the strict supervision of a doctor with specific qualifications.
If you feel unwell (dizziness, chest pain, etc.) while performing the training,
immediately stop
the exercise and consult a doctor.
Before starting any workout, make sure
your position on the unit is correct
, and be careful with any components that might constitute an obstruction.
Plan the workout according to your physical characteristics and state of health, beginning with less demanding workloads.
Do not overexert yourself or work to exhaustion. If you feel pain or unusual symptoms, stop training immediately and seek medical assistance.
Incorrect or excessive workout may cause physical harm.
Wear proper workout clothing and shoes during training; do not wear loose clothing. Tie long hair back. Keep garments or towels away from moving parts.
During use other people must remain at a safe distance.
Do not use the unit when children or pets are present.
Completely assemble the unit before using it. Check the equipment before each use, and check that the cable is correctly routed inside the races
of all the pulleys and the state of wear of the cable. If there are signs of wear, contact the Technogym Technical Support service. Do not continue to
operate the unit when it is not working properly.
Assemble and operate the unit on a solid, level surface.
Keep the equipment in good operating condition. If you see signs of wear, contact Technogym's technical support service.
Make sure that the load selection pin is fully inserted. Use only the pin provided by the manufacturer. Contact the staff for any questions.
Only remove the pin when the weight stack is in the rest position. The weight stack is in the rest position when both the weights and the crosspiece are
not in the air. If the weight stack is not in the rest position, contact floor staff and do NOT use the equipment.
Do not attempt to perform maintenance operations on the equipment other than those described in the user manual.