‘User Manual’’ Automatic Satellite Antennas TECHNO-MEDIA SRL
UMN_00094001
Rev 7
TECHNO-MEDIA SRL
Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - [email protected]
13
Antenna Installation
Verify that there is enough space on the roof of the vehicle
in order to allow the antenna movement. The antenna
always opens first vertically and then horizontally to allow
you to reduce the overall operating conditions but, in far
south regions, such as Morocco or North Africa, to point
the antenna of some satellites could tip very back, so it is
necessary that there are no objects that prevent its
rotation.
Consider a space of about 130 cm in diameter
around the antenna as shown.
Thoroughly clean the area identified for fitting and
removing all traces of grease, dust and debris.
With a caulking gun, apply a uniform layer of
polyurethane adhesive on the baseplate of the
antenna body (Area 1). Refer to the operating instructions of the adhesive used. Use
adhesives compatible with the counter material (ABS) and the roof of your vehicle.
Then position the antenna in the above cleaned area
by paying attention to the direction. The arrow in the
figure indicates the direction of march of the vehicle.
Be sure that the antenna is parallel to the sides of
the vehicle.