34
Status line
The top part of the display shows the output status, messages, faults, date and time.
Output status
Active
outputs are highlighted against a
green
background.
In the following example, outputs 1, 3 and 6 are active.
Output 5 has been
deactivated
manually (Manual/OFF) and output 6 has been
activated
manually
(Manual/ON). Outputs that have been switched to Manual/OFF or Manual/ON are marked with a
hand symbol
under the output number.
When a message is active, outputs may be switched to dominant off or dominant on. This is indicat
-
ed by a red border around the affected output.
Output pairs (e.g. for mixer drive) are shown in the status line with a
+
between the output numbers.
Example
: Outputs
8+9
and
10+11
have been programmed as output pairs
Tapping the outputs display takes you to the
Outputs
menu.
System values (date, time, location)
The system values
Date
and
Time
are shown in the status line at top right.
Tapping that status field takes you to the menu for the system values.
Example:
