IP COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
597
ip rtconfig
Modify a route of the routing table.
SYNTAX:
ip rtconfig
dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[label = <{None|DSCP|Interactive|Management|
SIPS_RTP|SIPS_SIG|Video|VoIP-RTP|VoIP-Signal|
default}>]
[gateway = <ip-address>]
[intf = <{loop|ipsec0|Internet|lan1|wan1|dmz1|
guest1}>]
[srcintf = <{loop|ipsec0|Internet|lan1|wan1|
dmz1|guest1|None}>]
[static = <{disabled|enabled}>]
[status = <{down|up}>]
[metric = <number{0-255}>]
where:
dst
The destination IP address(es) using this route. Supports ip/
mask notation.
REQUIRED
dstmsk
The destination IP address mask.
OPTIONAL
label
The name of a label.
OPTIONAL
gateway
The IP address of the next hop (direct connected gateway
or extended route)
OPTIONAL
intf
Only for special interface routes : the outgoing IP interface
name.
OPTIONAL
srcintf
Use this interface for source address selection.
OPTIONAL
static
Route persistency: static or dynamic (note that not all routes
can be changed).
OPTIONAL
status
The administrative state of the route.
OPTIONAL
metric
The metric for this route (weight factor).
OPTIONAL
nickdj.co.uk