SYSTEM COMMANDS
1064
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
system config
Set or change system config parameters.
SYNTAX:
system config
[upnp = <{disabled|enabled}>]
[tr64 = <{disabled|enabled}>]
[tr64sessiontimeout = <number{30-45}>]
[tr64auth = <{disabled|enabled}>]
[mdap = <{disabled|enabled}>]
[led = <{blue|green|red|orange|flash|off}>]
[resetbutton = <{disabled|enabled}>]
[defaultconnection = <{loop|Internet|lan1|
wan1|dmz1|guest1}>]
[autosave = <{enabled|disabled}>]
[autosavedelay = <number{0-600}>]
[WANMode = <{ADSL|VDSL|SHDSL|ETH|UMTS}>]
[WANEthPort = <{ethif1|ethif2|ethif3|ethif4|
ethif5}>]
where:
upnp
Enable/Disable upnp discovery
OPTIONAL
tr64
Enable/Disable TR-64 discovery
OPTIONAL
tr64sessiontimeout
TR-64 session timeout value (sec)
OPTIONAL
tr64auth
Enable/Disable TR-64 digest authentication
OPTIONAL
mdap
Enable/Disable mdap discovery
OPTIONAL
led
Set system LED color
OPTIONAL
resetbutton
Enable/Disable reset-to-factory-defaults pushbutton
OPTIONAL
defaultconnection
The name of the default internet connection.
OPTIONAL
autosave
Enable/Disable autosaves
OPTIONAL
autosavedelay
Autosave delay in seconds (0 for immediate save)
OPTIONAL
WANMode
Set autosensing wan mode
OPTIONAL
WANEthPort
Set autosensing eth wan port
OPTIONAL
nickdj.co.uk