100BASE-T1 MediaConverter_BCM
User Manual
11
3
Configuration
The 100BASE-T1 MediaConverter is configured by two
DIP switches
on the front of the
device.
DIP-Switch
Status
Description
1
ON (up)
OFF (down)
100BASE-T1 Port is set to Master
100BASE-T1 Port is set to Slave
2
ON (up)
OFF (down)
100BASE-T1 Port is set to FullOut
100BASE-T1 Port is set to HalfOut
Table 4: Configuration of DIP-Switches
In a 100BASE-T1 Link, one device must be set as Master, the other must be set as
Slave.
The 100BASE-T1 MediaConverter_BCM should always be set to FullOut. HalfOut
was a former configuration for EMC optimization but it will cause an unstable link.
