100BASE-T1 SPY 12 Port
User Manual
30
3.4.5
LIN Port
By clicking on the
LIN
port label allows to configure:
Figure 3-15: Parameters to set in LIN Port
Output to:
This allows the user to select which Gigabit port will be connected to the
LIN port. To activate the port logging, the Header must be enabled in the
Spy
Multiplexer
page (see Chapter 5.4.2.)
LIN mode:
Allows to select if the LIN port is working as Master, Spy or in Slave mode.
Note:
In the Master mode, the 100BASET1_SPY will send the information from Gigabit
to LIN port, when it receives a specific Ethernet frame (see Chapter 5.4.6.1).
Note:
In the Spy mode, the 100BASET1_SPY will log the information - only if the Header
is enabled in
Spy Multiplexer
(see section 5.4.2) - through the Gigabit Port selected in
the field
Output to
.
