CM CAN Combo
User Manual
21
Bootloader version
: The current bootloader version of your CM_CAN_Combo is
displayed here.
Controller IP address
: The Current configured IP address of the 100BASE-T1 port
(
Host
) (see
C
) on the frontside is displayed here.
HW-IP address
: The current IP address of the configuration port (RJ-45 Port or
100BSE-T1 Port SPY Core) (see
C
) is displayed here.
Serial number
: The Serial number of the CM_CAN_Combo is displayed here.
4.3.2
IP addresses
Figure 4-4: IP addresses
There are two possibilities to access to the device:
Access by 100BASE-T1 port of the power connector at the frontside (
Host
)
Access by the GB-Port or the 100BASE-T1 Port (
SPY Core
). One of them is
configured as configuration port. By default, it is the GB-Port.
Controller IP address
: This is the IP address you get access to the Webserver by the
100BASE-T1 port (
Host
). This IP address can be changed here. Please type the new IP
address
in the field. After leaving the focus of this field or pressing “Enter” you can
save the changes.