11
EG
TIPS FOR ENERGY SAVING
DO NOT:
l
Block the air intake and outlet of the unit.
If they are obstructed, the unit will not work well, and
may be damaged.
l
Let direct sunlight into the room. Use sunshades,
blind or curtain.
DO:
l
Always try to keep the air filter clean. A clogged filter
will impair the performance of the unit.
l
To prevent conditioned air from escaping, keep
windows, doors and any other openings closed.
TROUBLEShOOTING
WARNING
l
The use of portable telephones near the air conditioner
may cause disturbance to its normal operation and must
be avoided. In case abnormal operation is noticed,
(OPERATION lamp lights, but the air conditioner will not
run) to restore normal operation turn-off electric supply
for about 3 minutes, by disconnecting the main switch
or the wall plug, then start again the air conditioner.
If your air conditioner does not work properly, first check
the following points before requesting service.
If it still does not work properly, contact your dealer or
service centre.
Trouble:
the air conditioner does not run at all.
Possible cause:
1. Power failure.
2. Leakage breaker tripped.
3. Operation button is OFF.
4. Batteries in remote control unit have run down.
Remedy:
1. Restore power.
2. Contact service centre.
3. Press the button again.
4. Replace batteries.
Trouble:
Poor cooling or heating performance.
Possible cause:
1. Dirty or clogged air filters.
2. Heat source or many people in room.
3. Doors and/or windows are open.
4. Obstacle near air intake or air discharge port.
5. The set temperature on the remote control unit is too
high.
6. Outdoor temperature is too low (heat pump version).
7. Defrosting system does not work (heat pump version).
Remedy:
1. Clean air filters to improve airflow.
2. Eliminate heat source if possible.
3. Shut them to keep the heat or cold out.
4. Remove it to ensure good airflow.
5. Set the right temperature on the remote control unit.
6. Try to use a back-up heater.
7. Consult your dealer.
Trouble:
Clicking sound is heard from the air conditioner.
Possible cause:
1. During operation, any plastic parts may expand or
shrink due to a sudden temperature change. In this
event, a clicking sound may occur.
Remedy:
1. This is normal, and the sound will disappear when an
even temperature is settled.
A C T I V A T E D C A R B O N A I R F I L T E R
(ACCESSORY SUPPLIED ON REQUEST)
NOTE
1. The activated carbon air filters are in a polyethylene
bag.
2. Open the bag just before installing the activated carbon
air filters, otherwise, the deodorizing effect durability of
the filter may be decreased.
The activated carbon air filter is to be added to the
standard filter.
It is made of two layers:
- the first layer consists in a synthetic honey comb high
efficiency media to remove the dust and purifing the
air.
- the second layer in charcoal media deodorizing the
ambient air.
REPLACEMENT OF ACTIVATED CARBON
AIR FILTER
l
The filter is disposable.
l
Do not throw away the filter frame, if present.
l
The used filter cannot be reused even after cleaning up.
l
Obtain the filters for replacement at your nearest dealer.
l
Check the state of dirtiness at least once every two
weeks.
l
Replace the filter after six months’ operation.
This activated carbon air filter cannot remove harmful
gases or vapors nor ventilate air in the room. You must
open doors or windows frequently when you use gas or oil
heating appliances. Otherwise there is a risk of suffocation
in an extreme case.
WARNING
ACTIVATED CARBON AIR FILTER INSTALLATION
PROCEDURE
1.
Open the unit intake air grille and pull out the standard
air filter.
2.
Apply on the rear side of the filter the two spings
supplied with the accessory.
3.
Fix the activated carbon filter by the springs.
4.
Insert the two air filters one over the other and close
the intake grille.
REAR SIDE OF
AIR FILTER
SPRING
ACTIVATED CARBON
FILTER