PARTS LIST
ATTENTION: Before you begin the assembly,
make sure that all parts are included in good
condition.
ASSEMBLY INSTRUCTIONS FOR TECHNI SPORT CHAIR MODEL
RTA-TSXXL2
ATTENTION:
⚠
Follow the instructions step by step.
⚠
To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places.
⚠
Do not overtighten or force the screws as they could break, strip, or damage the threads of the holes.
⚠
Using the wrong size of screws on a part could result in damage to the screw or the part.
E
F
H
G
B
D
N
M
I
O
Q
Backrest, x1
Seat, x1
Mechanism,
x1
Hydraulic
Gas Lift, x1
Covers for
Gas Lift, x1 set
Star Base, x1
Caster, x5
J M N
Insert the casters (H) into the legs of
the base (G) using pressure.
REMOVE AND DISCARD THE PLASTIC
CAP FROM THE TOP OF THE GAS LIFT
(E),
and place the gas lift in the middle of the
base and cover it with (F) as shown.
Place the seat (B) upside-down with
its back end towards you as shown.
Using screws (J), O ’rings (M) and washers
(N), assemble the mechanism (D) to the
seat with its handle facing to your LEFT.
Assemble the armrests (C) to the
seat (B) on their respective sides using
screws (J), O’ rings (M) and washers (N).
IMPORTANT: Assemble the arm brackets
pushed all the way in!
Assemble the backrest (A) to the
metal brackets on both sides of the
seat (B) using screws (K), o ’rings (M) and
washers (N) as shown.
M8x20mm, x10
(Mechanism, armrests)
(Backrest)
Tighten the screws well before you sit on the
chair for the first time.
REMOVE
CAP!
Place the seat over the base
making sure the tip of the gas lift
enters in the hole of the mechanism,
and place the lumbar pillow (Q).
I
A
C
D
Armrests
(Sitting on the chair,
Not looking at it)
E
F
Hole covers, x4
O
Washers, x14
N
O” Rings, x14
M
M5x8mm, x2
L
M8x25mm, x4
K
J
Bracket Covers
Left
(Back end of seat)
L
Right
B
G
H
P
Allen Wrench, x1
Lumbar Pillow,
x1
Q
(Brackets)
Left
Right
(4 sets of
hardware)
P
J
M
N
P K M N
K (LEFT)
K (RIGHT)
P
L
P L
O
A
Attach the covers (K) to the brackets
on their respective sides using
screws (L), then cover the holes with (O) as
shown.
C
(LEFT)
C
(RIGHT)
N
(6 sets of
hardware)
P
J
M
B
