7
Basic Setup Wiring Diagrams
There are two basic ways to use the fixture. One is in standalone, which does not require the
use of any data lines to be connected nor any controller, each fixture would operate
independently based solely on the menu setting. The second method, is to use the units in DMX
control. The second method requires the fixtures to be wired together via the DMX DATA in and
out cables. This allows the units to receive data either from the master unit or the DMX
controller. Data wiring is explained in more detail in the DMX Data Connection section of this
manual.
Example Block Diagram
Operating Setting Buttons
The following refers to the settings that are available on this fixture via the LED Segment
Control Panel display. All functions are selectable from the display menu located at the back of
the fixture using the four push buttons: Menu, Up, Down, Enter
Press MENU to return to the upper menu; Press UP or DOWN to scroll into the menu options or
to adjust the values. Press ENTER to confirm.
After power on and initialization, it will show the status before last power off. Then, the unit is
ready for settings and operation. Please see the following table for setting information.
